close

Before You Call...

Can We Help?

1.Technical questions? Our operatives cannot answer these. Please email your requirements and photos of seals or rollers to help@theshowerseal.co.uk and we will respond quickly, however our full range is listed online so if you don’t see it on our site we don’t stock it. Please don’t send us samples in the post as these cannot be returned

2. Need to place an order? It’s easy, safe and secure to order online, however you can order any of the products shown on the site paying over the phone if you prefer.

3. Tracking queries? Did you check your email for the tracking link if applicable to the service purchased?

Need to call us about something else?

01423222455

850MM SEALS AND ROLLERS FREE DELIVERY TO ALL UK INCLUDING HIGHLANDS, ISLANDS AND N.I.
DELIVERY CHARGES APPLY TO LONG ITEMS EG 2M SEALS
SILICONE EATER EVERBUID 150MLSILICONE EATER EVERBUID 150ML
Move your mouse over image or click to enlarge

SILICONE EATER EVERBUID 150ML

Availability: Out of stock

From: £5.20

Quick Overview

SILICONE EATER EVERBUID 150ML

Details

Product Description

EVERBUILD SILICONE EATER is a revolutionary product specifically designed to remove all silicone based sealants and surface water repellents - cured and uncured. The product acts by digesting silicone polymers making them easily water or solvent rinsable.

 Benefits

  • Readily digests silicone
  • Ready for use gel - may be used vertically as well as horizontally with no slump.
  • Does not contain halogenated solvents, heavy metals, cyanide etc.
  • Water clean up.
  • Low hazard formulation

 Areas For Use

  • May be used on aluminum* and its alloys, copper and its alloys, iron, steels, glass, ceramics, epoxy composites, most plastics.
  • Has little effect on rubber and other elastomers.
  • Has little effect on most painted surfaces.

 

Limitations

*TEST A SMALL AREA BEFORE USE. In all cases, apply a small test patch to an inconspicuous area. Leave for 2 hours min and rinse off. Check for staining/corrosion before attempting the whole job.

* May attack nylon, certain fabrics/textiles and coloured anodised aluminum (used as a trim around showers), PU coated (re-enameled) baths, fluoroacrylics, chipped surfaces.

                               

Surface Preparation

All surfaces must be clean, dry and dust free. Cut away as much as possible of the silicone sealant using a sharp knife. Protect surrounding areas with impervious masking tape

 

Application

Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut at an angle of 45o with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the trigger and keeping the gun at a constant angle to the surface being sealed.